![]() ![]() the first place being the BIOS of your computer. What we need to do is to adjust the power settings. and run less programs, and don't have so many devices. This is the reason why they stop working in EG. so it thinks they are still removed from the system. In some cases the devices will get plugged back in (powered on) before EG resumes so it never sees the devices get added. When the computer resumes the same thing happens with the devices power being turned back on and the applications being told to start running again. So EG sees the devices get unplugged and then the computer goes into a low power state. If you have EG as one of the first things to run you will be less likely to have this problem. But essentially what is happening is the devices are getting powered down before EG gets the notification of the power state change. Also the speed of your computer has to deal with it as well. it will sometimes happen and sometimes not. but depending on how many applications you have running and what order you started them in is going to make this a ghost problem. When windows goes into one of these states it will power down your devices and notify the programs. ![]() When windows goes into Sleep/Hibernate/Standby basically any kind of a lower power consumption state this issue will arise. Specifically with how windows handles it's power state changes and notifications of the programs when this state changes. "The issue is not with EG (technically) It is with windows. On some occassions, windows will install "Dvico Remocon V1.00" driver, but on most occassions it seems to just go for "USB Input Device". Still no go, any guru out there who has experience with this issue? I have researched a fair bit and have tried the following:-ġ) regedit all USB devices and "ForceHCResetOnResume"Ģ) use a $5 USB hub controller from the mobo usb ports, and plug the remote receiver into one of these portsģ) tried all different USB ports on the moboĤ) used MCEStandby Tool (which also tries the ForceHCResetOnResume) Simply unplugging it for 1-2 seconds resolves the issue as the USB Input device driver is then correctly installed, and bingo, I can use my Logitech Harmony for full remote facilities. I have a HTPC that was running Win 7, and used a Fusion Dvico remote (plugged into USB port) for control of my WMC, and also Emby.Īfter upgrading, finally to Win 10, I have a curious but not unheard of problem, that when the HTPC is turned on, the remote IR receiver driver is not automatically loaded. Hey guys, This is not so much an emby problem, just looking for any expert advice from the community. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |